Pipework Corrosion Protection Without Blasting
NanoPrep protects pipework without blasting
Download Case StudyThe Problem
An offshore Oil & Gas facility required coating remedial work carried out on pipework located in areas where it was not possible to perform surface preparation by abrasive blasting due to wet and icy surfaces, and the costs associated with shutting down operations.
Condition of pipework before coating remedial work
The Application
NanoPrep was selected as the preferred surface preparation solution as it provided an effective, low cost alternative to abrasive blasting in the form of a simple low pressure power wash (3500 psi) combined with power tool cleaning. In addition, it is suitable for a variety of topcoats and can be applied to rusted, damp or dry surfaces. After application, a final layer of PPG PSX 700 was applied.
Two coats of NanoPrep applied by brush at 75μm
One coat of PPG PSX 700 Topcoat applied at 75μm
The Outcome
Using NanoPrep for surface preparation proved to be a highly effective solution, delivering a rapid turnaround by eliminating the need for abrasive blasting. This allowed the customer to ensure long-term protection of the pipework without operational shutdowns whilst saving time and money. Six years on, the coating remains in very good condition.
Project Specification
| Item | Detail |
|---|---|
| Industry | Oil & Gas — Offshore |
| Application | Offshore pipework — confined areas |
| Surface condition | Corroded carbon steel — wet and icy surfaces |
| Surface preparation | Low-pressure power wash (3500 psi) + power tool clean |
| NanoPrep | Two coats applied by brush at 75μm |
| Topcoat | PPG PSX 700 — one coat at 75μm |
| Key requirement | No blast cleaning, no operational shutdown |
More Information?
For more information about NanoPrep products and services, fill out the form below and one of our team will be in touch within 1–2 business days.
Frequently Asked Questions
Can corroded offshore pipework be coated without abrasive blasting?
Yes. On an offshore oil and gas facility in New Zealand, Rezitech used NanoPrep to prepare and protect corroded carbon steel pipework where abrasive blasting was not possible. The surface was prepared with a 3,500 psi pressure wash and power tool cleaning, then coated with two coats of NanoPrep and a topcoat, with no blasting and no operational shutdown.
How do you prepare rusted pipework for NanoPrep?
Firmly adhered rust does not need to be removed. On this offshore project the pipework was cleaned with a 3,500 psi pressure wash followed by power tool cleaning to remove loose rust and coating. NanoPrep was then brushed on in two coats of 75 microns each, where it reacts with the remaining rust to form a stable base for the topcoat.
Can NanoPrep be applied to damp steel?
Yes. NanoPrep can be applied to rusted, damp or dry steel surfaces. That made it suitable for this offshore pipework, where wet and icy conditions ruled out abrasive blasting. Avoiding blasting also meant the facility did not have to shut down operations to carry out the coating work.
Can NanoPrep be used with other topcoats?
Yes. NanoPrep is suitable for a variety of topcoats. On this offshore pipework project, one coat of PPG PSX 700 was applied at 75 microns over two coats of NanoPrep. For most projects Rezitech recommends R230 TopCoat, a water-based, UV-resistant topcoat designed for use over NanoPrep. Contact Rezitech to confirm the right topcoat for your environment.